Upgrade Your Monster Grinder
to the Latest Technology

Have an old Muffin Monster®? What about an old Channel Monster®? Or an old HYDRO? JWC Service Solutions can upgrade your old unit to the latest model. Enhanced functionality, improved reliability, and better serviceability are what you gain by upgrading your old unit.  And many of these upgrades require no change to your old unit’s controller, motor, reducer, and framework.

Upgrading Your 30001 Muffin Monster?

  • Upgrade to a 30004T Muffin Monster
  • Uni-body single piece housing = easy cutter exchange
  • Mechanical seal cartridges = higher operating pressure
  • Wipes Ready® cutters
  • Optimum cut control

Upgrading Your 30002 Muffin Monster?

  • Upgrade to a 30005 Muffin Monster
  • Delta P Side Rails = up to 66% higher flow capacity
  • Mechanical seal cartridges = a higher operating pressure
  • Wipes Ready cutters
  • Optimum cut control

Upgrading Your -MS, -GTS & -AD Series Channel Monster?

  • Upgrade to a –XD series Channel Monster
  • Perforated drums prevent bypass of debris without sacrificing flow rate
  • Wipes Ready cutters
  • Optimum cut control
  • Vertical shaft collar support to limit shaft deflection
  • 4 full-swivel hoist rings for superior lift capability

Upgrading Your -XD Series Channel Monster?

  • Upgrade to a Channel Monster FLEX
  • Modular FLEX grinder and solids diverter with a perforated screen connected by a FLEX frame
  • Easy field replacement of separate FLEX grinder and solids diverter
  • Optional 10-hp motor for most powerful Monster grinder
  • Highest flows without sacrificing solids capture
  • Incorporates best Monster technologies
    • Wipes Ready cutters
    • Optimum cut control
    • Vertical shaft collar support to limit shaft deflection
    • Severe duty seals = highest operating pressure

Upgrading Your 3-HYDRO-I?

  • Upgrade to a 3-HYDRO-IX
  • Uni-body single piece housing = easy cutter exchange
  • Mechanical seal cartridges = a higher operating pressure
  • Wipes Ready cutters
  • Optimum cut control

Why Upgrade to Wipes Ready?

Rags, wipes and other non-dispersables are clogging pumps and damaging wastewater treatment systems. Wipes Ready technologies from JWC will keep your system running efficiently. *Wipes Ready technology is only available on the latest Muffin Monster, Channel Monster and HYDRO grinders – another reason to upgrade your old unit to the latest technology.

17-tooth Wipes Ready Cutters

  • Serrated edges
  • Knurled spacers
  • Cuts in two directions

Delta P Side Rails

  • Superior capture and directing solids into cutters
  • Material hydraulically washed into cutters

½-inch Perforated Drums

  • 59% better capture than coil drum
  • Resists build-up of grease or other material

Optimized Cut Control

  • Better cutter clean out
  • Better cutting to small strips